Asante Technologies 480 - Manual (Page 110)

Format ping <A.B.C.D>
Mode User Mode
10.2.5 show
1
） show port
This command displays port status.
Format show port {<port#> | all}
Mode User Mode
2
） show network
This command displays switch IP configuration
Format show network
Mode User Mode
3
） show system
This command displays system information.
Format show system
Mode User Mode
4
） show port statistics
This command displays port statistics.
Format show port statistics {<port#> | all}
Mode User Mode
10.2.6 enable
Enter to the Privileged Mode
Format enable
Mode User Mode
10.3 Privileged Mode commands
10.3.1 cable-diag
15
This command is used to proceed cable diagnostic
Format cable-diag port <port ID>
Mode Privileged Mode
e.g. Switch#cable-diag port 1
10.3.2 clear
10.3.2.1 clear arl
This command is used to clear ARL table entries
Format clear arl
Mode Privileged Mode
1) clear arl dynamic
This command is used to Clear dynamic arl table entries
Format clear arl dynamic
Mode Privileged Mode
2) clear arl static
This command is used to clear static arl table entries
Format clear arl static mac <mac-addr>
Mode Privileged Mode
10.3.2.2 clear config
This command is used to restore switch factory default configuration
Format clear config
Mode Privileged Mode
10.3.2.3 clear counters
This command is used to clear RMON statistics for entire switch
Format clear counters
Mode Privileged Mode
10.3.2.4 clear IGMPsnooping
This command is used to restore igmpsnooping configuration to factory default
110 Asante IntraCore IC39240/480 User’s Manual