Pfister VTP-E21W - Manual (Page 3)

EN
G
LI
SH
ENGLISH
8
9
11
10
8 WAX SEAL INSTALLATION
Carefully turn Toilet’s Base (8A) on it’s side on top of a Secure Padded Surface (8B).
Place Wax Seal (8C) firmly into the outlet of the toilet bowl.
10 TOILET BOWL INSTALLATION
A. Place Toilet’s Base (10A) onto Waste Outlet Hole (10B) with Tee Bolts (10C) passing
through Fixing Holes (10D).
B. Place the Plastic Washer (10E) and Metal Washer (10F) onto Tee Bolts (10C). Secure
by tightening the Mounting Nuts (10G) on to the Tee Bolts.
Do not over tighten!
Snap on Plastic Caps (10H) over bolts and nut as shown.
9 TANK INSTALLATION
The tank comes pre-installed with flushing mechanism. Attach Large Hose Nut (9A) to
Fill Valve Shank (9B) located on bottom of Tank (9C). Insert Rubber Gasket (9D) into
Water Inlet Hole (9E) on top of Bowl Shelf (9F). Place Tank (9C) on top of Bowl Shelf
(9F) and align Brass Bolts (9G) and insert Hose (9H) through corresponding Shelf
Holes (9J). From underneath bowl, screw Locking Nuts (9K) and Washers (9L) onto
Brass Bolts (9G) and tighten as shown.
Do not over tighten!
11 WATER SUPPLY CONNECTION
Connect Short Hose Nut (11A) onto Water Supply Valve (11B). Turn on Water Supply
Valve (11B) by turning Handle (11C) counterclockwise.
12 INTERNAL PLUMBING
Tank comes pre-installed with flushing mechanism.
3
8A
8B
8C
11C
11A
11B
10F
10G
10C
10H
10E
10A
10B
10C
10C
10D
9J
9H
9C
9D
9G
9E
9F
9A
9L
9K
9B
OPEN
A
B