Yokogawa 202 Field Mounting Rate Totalizer - Manual (Page 43)

Installation 39
9.3 REMOVING THE FRONT PANEL
The front panel should be removed as follows:
1. Remove the top and bottom cover strips (ie. the dark plastic strip) by
levering a screwdriver under one end.
2. Undo the screws retaining the front. Do not remove the screws, they are
retained by O-rings.
3. Remove the front panel from the housing.
To replace the front cover, follow the above procedure in reverse. Ensure that the
front panel is aligned at connector points before tightening the screws.