Yokogawa Removable Chassis DX1000N - Manual (Page 21)

21
IM 04L41B01-03E
DAQSTANDARD for DXAdvanced
The functions below have been added or changed since DAQSTANDARD revision 7.21.
Hardware Configurator
Setup Menu Corresponding to the DX Functions of Firmware Version 2.0x
• Specifying the Base Position of the Bar Graph
Applies to the operations on the [Measure channel], [Math channel], or [Ext channel]
tab screen.
Bar Display Position
Set the base position of the bar graphs to [Normal], [Center], [Lower], or [Upper].
Operations on the DX1000/DX1000N/DX2000: Page 6
• Alarm Output Relay Action When the Alarm ACK Operation Is Executed
Select [Alarm] on the [Basic Setting] tab screen.
Relay Action on ACK
Normal The relay output is deactivated when the alarm ACK operation is executed.
If the condition for activating the alarm output relay is met in the next scan
interval, the relay output is activated.
This operation is valid only when the alarm output relay is set to [Hold].
Reset The relay output is deactivated when the alarm ACK operation is executed. If
a new condition for activating the alarm output relay, the relay is activated.
Operations on the DX1000/DX1000N/DX2000: Page 9
• Storage Method for Constantly Retaining the Most Recent Data Files in
the CF Card (Media FIFO)
Select [Environment] > [Detail Setting] on the [Basic Setting] tab screen.
Media FIFO
This is valid only when [Auto Save] is [ON].
ON If there is no more free space on the CF card, the oldest file is deleted, and the
newest file is saved.
OFF If there is no more free space on the CF card, the measured data is not saved to
the CF card.
Operations on the DX1000/DX1000N/DX2000: Page 12