Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 4)

IM 04L31Q01-04E 1
1.1 Overview of CX Operator
CX Operator allows you to execute recording START/STOP and control loop operations with monitoring
measurement/control screen. Operation screens such as CX trend screen, control screen, and program
screen can be switched and monitored from remote site. Operations related to trend recording,
control operation such as parameters (SP, OUT, operation mode) can be executed from remote site.
Connect available instruments: The following model after Style3 including special specification
(/S33 and /S35)
CX1000,CX1006, CX1200, CX1206
CX2000, CX2010, CX2020, CX2200，CX2210, CX2220, CX2410, CX2420, CX2610, CX2620
Note
• Simultaneous use with DAQWORX
It is recommended to login by an administrator level for the CX operator:
- DAQEXPLORER can not be used simultaneously.
- Please login by user level for DAQLOGGER.
• Simultaneous use with Web browser:
Please use “monitor mode” not “operator mode” for CX Web browser.
•
When CX operation on site and CX operation from CX Operator are done simultaneously, there is a case that
an error message appears. In operating from CX Operator, do not operate on site.
1.2 Required PC System Environment:
z OS
Windows2000, Windows XP
z Personal computer
A computer which runs on Windows 2000, or Windows XP, and is equipped with a following
Pentium processor, Pentium II, 266 MHz or higher is recommended.
z Hard Disk
100MB or more (30 MB for desirable empty capacity)
z Monitor
A monitor supported by Windows 2000, or Windows XP. Resolution: 800 pixel or higher, number of
colors: 32 K or more (A monitor with 1024 x 768 pixels and 65536 colors is recommended)
Chapter 1 Before using CX Operator