Yokogawa DAQWORX - Manual (Page 29)

9 IM WX1000-01E
Operation Guide
Appendix
Installation Guide
Setting Up the Temperature Controller
Connect the Yokogawa’s UT351 temperature controller.
Enter settings on the UT350E as follows:
1. Hold down SET/ENT for three seconds or more to display .
2. Use or to display .
3. Press SET/ENT once to display .
4. Press SET/ENT once to display .
5 Press SET/ENT repeatedly (about twenty times) to display .
6. Use or to enter the IP address.
7. Press SET/ENT to save the settings.
8. Repeat steps 6 and 7 to enter IP addresses –4, subnet masks 1–4, and
default gateways 1–4.
IP address 1
IP address 2
IP address 3
IP address 4
Subnet mask 1
Subnet mask 2
Subnet mask 3
Subnet mask 4
Default gateway 1
Default gateway 2
Default gateway 3
Default gateway 4
IP address
0 to 255
IP1
0 to 255
IP2
0 to 255
IP3
0 to 255
IP4
Subnet mask SM1 SM2 SM3 SM4
Default gateway DG1 DG2 DG3 DG4
Setting the IP address, Subnet mask, and Default gateway
9. Press SET/ENT to display (Ethernet setting switch).
10. Use or to enter 1.
After setting to 1, it automatically reverts to 0.
11. Hold down SET/ENT for three seconds or more for numerical display.