American Dryer Corp. ADH-120 - Manual (Page 16)

12
1. Leveling Dryer
a. To level dryer, place 4-inch (10.16 cm) square metal shims (refer to the illustration on the previous
page) or other suitable material under the base pads. It is suggested that the dryer be tilted slightly to the
rear.
2. If more headroom is needed when moving dryer into position, the top console (module) may be removed.
a. To remove top console (module)
1) Disconnect the ground wire (A) at the rear upper left hand corner of dryer.
2) Remove the six (8) set of nuts and washers (B) holding the console (module) to base.
3) Open the control door/control panel and disconnect the white 15-pin plug connector (C in the
illustration below) located in the base of the control box.
4) Disconnect white plug connector located outside backside of the control box (provides power to heat
circuit).
5) Lift the console (module) off of the dryer base.
IMPORTANT: The dryer must be transported and handled in an upright position at ALL times.