Nexo PS-R2 - Manual (Page 15)

A MPLIFIER S ELECTION FOR USE WITH PS-S ERIES Page 15/82
Figure below shows connectors implementation on the rear panel.
3.2.2 PS Series and NXAMP recommended configurations
Below table lists basic requirements for proper use of NXAMP TD Controllers in conjunction with PS
Series:
Passive Mode Active Mode
1 or 2 PS8s 1 channel of NXAMP4x1 in 4 channels mode
1 or 2 LS400 1 channel of NXAMP4x1 in Bridge Stereo Mode
1 or 2 PS10 1 channel of NXAMP4x1 in Bridge Stereo Mode
1 channel of NXAMP4x4 in 4 channels Mode
1 or 2 LS600 1 channel of NXAMP4x1 in Bridge Stereo Mode
1 channel of NXAMP4x4 in 4 channels Mode
1 or 2 PS15 1 channel of NXAMP4x1 in Bridge Stereo Mode
1 channel of NXAMP4x4 in 4 channels Mode
2 channels of NXAMP4x1 in Bridge Stereo Mode
2 channels of NXAMP4x4 in 4 channels Mode
1 RS15 Omni 1 channel of NXAMP4x1 in Bridge Stereo Mode
1 channel of NXAMP4x4 in 4 channels Mode
Please refer to following documents (available at www.nexo-sa.com) for detailed information on specific
configurations:
- NXAMP4x1 and NXAMP4x4 User Manual
- NXAMP Application Guideline
- NXAMP Load Setup list