Nexo PS-R2 - Manual (Page 36)

Page 36/82 PS S ERIES HARDWARE SETUP PROCEDURE
Horizontal (PS15R2 only)
• Remove the four TORX screws holding connector plates on both side of PS15R2;
• Remove the connector plates from PS15R2;
• Fill each screw hole with Locktite 243 or equivalent;
• Position external plates from VNI-LBRK kits and secure them using the shoulder screws
supplied with these kits;
• Position “L” brackets from VNI-LBRK kits, and secure them to the cabinet using the 4 remaining
shoulder screws supplied with these kits.
• Slings and shackles (not provided) are required to secure the cluster under the ceiling;
CABLE SUSPENSION MOUNTING PROCEDURE FOR PS15R2
7.3.4 PS10R2 and PD15R2 wall suspension (vertical or horizontal)
Required item
Vertical
• 1 VNI-WS10 for PS10R2
• 1 VNI-WS15 for PS15R2
• 4 x 12mm diameter screws (not provided)
Horizontal
• 1 VNI-WS10 and 1 VNI-UBRK10 for PS10R2
• 1 VNI-WS15 and 1 VNI-UBRK12 for PS15R2
• 4 x 12mm diameter screws (not provided)
IMPORTANT
Ensure that the wall is strong enough to hold PS cabinet weight and that the screws
12mm diameter and corresponding plugs required to fix the VNI-WS on the wall are
properly dimensioned.