Nexo PS-R2 - Manual (Page 29)

PS S ERIES HARDWARE SETUP PROCEDURE Page 29/82
7 PS S
ERIES HARDWARE SETUP PROCEDURE
Before proceeding with installation of PS series, please ensure that the components are present and
undamaged. A component list is appended to this manual. In the event of any shortage, please contact
your supplier.
7.1 SAFETY FIRST
PS Series accessories structural computations and related documents are available at Nexo
([email protected]) upon request.
We include this section to remind you of safe practice when flying the PS Series. Please read it
carefully. However, user must always apply his or her knowledge, experience and common sense. If in
any doubt, seek advice from your supplier or NEXO agent.
The PS Series accessory range is a professional precision tool set, and should be handled with extreme
care. Only persons. Misuse of the these accessories could lead to dangerous consequences.
Used and maintained correctly, PS Series accessories will give many years of reliable service in
portable systems. Please take the time to read and understand this manual. Flown Systems Safety
• Always inspect all the rigging components and cabinets for damage before assembly. Pay
special attention to the lifting points, and safety clips. If you suspect that any of the components
are damaged or defective, DO NOT USE THE AFFECTED PARTS. Contact your supplier for
replacements.
• Read this manual carefully. Also be familiar with the manuals and safe working procedures for
any ancillary equipment that will be used with PS Series accessories.
• Ensure that all local and National regulations regarding the safety and operation of flying
equipment are understood and adhered to. Information on these regulations can usually be
obtained from Local Government Offices.
• When deploying a PS Series system always wear protective headwear, footwear and eye
protection.
• Do not allow inexperienced persons to handle a PS Series system. Installation personnel should
be trained in loudspeaker flying techniques and should be fully conversant with this manual.
• Ensure that motor hoists, hoist control systems and ancillary rigging components are currently
certified as safe and that they pass a visual inspection prior to use.
• Ensure that public and personnel are not allowed to pass beneath the system during the
installation process. The work area should be isolated from public access.
• Never leave the system unattended during the installation process.
• Do not place any object, no matter how small or light, on top of the system during the installation
procedure. The object may fall when the system is flown and is likely to cause injury.
• Secondary safety steels must be installed once the system has been flown to the operating
height. Secondary steels must be fitted irrespective of requirements of the local safety standards
applicable to the territory.
• Ensure that the system is secure and prevented from pivoting around the motor hoist.
• Avoid any form of excessive dynamic loading to the assembly (structural computations on PS
Series Rigging System are based on a 1/1.2 factor for hoist or motor acceleration).
• NEVER attach any item to the PS Series system other than the PS Series accessories.
• When flying outdoor systems ensure that the system is not exposed to excessive wind or snow
loads and is protected from rainfall.