2 speaker connection, 1 configuring connector and owner plates, 2 rs18 connectors – Nexo RS User Manual

Page 17

Advertising
background image

RS18

G

ENERAL

I

NSTRUCTIONS

Page

17/54

SP4

Connector

Top View

REAR

Speaker

FRONT

Speaker

FOH

SP4

Connector

Top View

REAR

Speaker

FRONT

Speaker

FOH

SP4

FOH

SP4

Or

1.2 Speaker

connection

1.2.1 Configuring Connector and Owner plates

Owner and connector plates can be exchanged depending on chosen directional configuration.

Please note that connector plates can pass through the holes, it is therefore not required to unsolder the
connectors.

• Directional Mode : it is recommended to install the connector panel on the side which supports the

rigging plates;

• Connection side is always opposite to FOH (main lobe direction)

CONNECTOR PLATE IN DIRECTIONAL MODE

• Omni Mode: it is recommended to install the connector panel on the side opposite to the drivers

(factory default configuration)

CONNECTOR PLATE IN OMNI MODE

1.2.2 RS18

connectors

RS18 is connected through Speakon NL4FC plugs (not supplied).

Either connector can be used to connect an amplifier or to link to an additional RS18 cabinet.

Connectors are wired as follows:

Speakon NL4F

Connectors

Omni Mode

Directional Mode

Comment

1(-)

18’’ driver Right (-)

18’’ driver Rear (-)

1(+)

18’’ driver Right (+)

18’’ driver Rear (+)

Driver Next to Connector

Panel

2(-)

18’’ driver Left (-)

18’’ driver Front (-)

2(+)

18’’ driver Left (+)

18’’ driver Front (+)

Driver Opposite to

Connector Panel

Advertising
This manual is related to the following products: