Installation instructions – Activeforever CL 100-C User Manual
Page 9
Comfort Line Products, Inc.
9
INSTALLATION INSTRUCTIONS
SITE PREPARATION
A.
Structure: Your spa should always be installed on a
structurally sound, relatively smooth and level surface.
B.
Electrical: The installation should be a grounded 120 volt
outlet within 8 feet of the spa and allow for easy access to the
cord mounted GFCI for periodic testing.
C.
A copper wire connector is located in the Power Pack to
permit connection of a minimum No. 8 A.W.G. solid
copper bonding conductor between any metal equipment,
water pipe, or metal enclosures within 5 feet of the spa as
required to comply with the National Electric Code, or local
requirements.
INDOOR INSTALLATION
Give special consideration to the following issues when installing your
spa indoors.
1.
Make sure the floor can support the total spa filled weight of 2569
pounds.
2.
Install your spa on water resistant, non-slip floor. The floor should
have a drain to remove water splashed from the spa. Do not
install the spa on carpet or other material that will be damaged by
moisture.
3.
Take into consideration the room humidity which will exist due to
high temperatures. Providing natural or forced ventilation in the
room will help maintain comfort and minimize moisture damage
to the surrounding environment.
4.
Avoid installing the spa indoors on a second story above finished
living space due to the possibility of water and humidity damage.
5.
Allow enough clearance around the spa for full access to the spa
equipment for service.