Mammoth 2 to 6 Tons: High Efficiency, Superior IAQ Single Circuit Vertical (B-Vintage) - Manual (Page 5)

5
MAMM-WSHP-IOM-1BA (February 2012)
Unit Location and Clearances
Units can be mounted on the floor or a concrete pad,
typically in a mechanical closet or other area enclosed
from the space to promote a quieter occupied environ-
ment.
The diagrams below show minimum suggested clear-
ances. Any additional clearances would be beneficial,
but not always necessary. The requirements on any
specific unit may increase or be reduced depending on several factors such as maintenance requirements and
mechanical or electrical installation codes. If return air
is not ducted, enough clearance will be required to pro-
vide for adequate airflow.
Units need to be accessed on three sides; two panels
for the compressor and blower, one for the electrical
panel and compressor compartment. Unit filters are
removed from the right or left side.
Unit clearances