Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 173)

Multi-Service IronWare Multicast Configuration Guide 161
53-1003032-02
IPv6 PIM Sparse
2
Brocade(config)# ipv6 router pim
Brocade(config-ipv6-pim-router)# prune-wait 2
To change the default join override time to 2 seconds for a specified VRF, enter commands such as
the following.
Brocade(config)# ipv6 router pim vrf blue
Brocade(config-ipv6-pim-router-vrf-blue)# prune-wait 2
Syntax: [no] prune-wait seconds
The seconds parameter specifies the number of seconds. The valid range is from 0 through 30
seconds. The default is 3 seconds.
Setting the register suppress interval
The register-suppress-time command allows you to set the amount of time the PIM router uses to
periodically trigger the NULL register message.
NOTE
The register suppress time configuration applies only to the first hop PIM router.
To change the default register suppress time to 90 seconds, enter commands such as the
following:
Brocade(config)# ipv6 router pim
Brocade(config-ipv6-pim-router)# register-suppress-time 90
To change the default register suppress time to 90 seconds for a specified VRF, enter commands
such as the following:
Brocade(config)# ipv6 router pim vrf blue
Brocade(config-ipv6-pim-router-vrf-blue)# register-suppress-time 90
Syntax: [no] register-suppress-time seconds
The seconds parameter specifies the number of seconds. The valid range is from 60 through 120
seconds. The default is 60 seconds.
Setting the register probe time
The register-probe-time command allows you to set the amount of time the PIM router waits for a
register-stop from an RP before it generates another NULL register to the PIM RP. The register
probe time configuration applies only to the first hop PIM router.
NOTE
Once a PIM first hop router successfully registers with a PIM RP, the PIM first hop router will not
default back to the data registration. All subsequent registers will be in the form of the NULL
registration.
To change the default register probe time to 20 seconds, enter commands such as following.
Brocade(config)# ipv6 router pim
Brocade(config-ipv6-pim-router)# register-probe-time 20
To change the default register probe time to 20 seconds for a specified VRF, enter commands such
as the following.
Brocade(config)# ipv6 router pim vrf blue
Brocade(config-ipv6-pim-router-vrf-blue)# register-probe-time 20
Syntax: [no] register-probe-time seconds