Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) User Manual
Page 64
52
Multi-Service IronWare Multicast Configuration Guide
53-1003032-02
Multicast Outgoing Interface (OIF) list optimization
1
Displaying PIM Sparse configuration information
and statistics
You can display the following PIM Sparse information:
•
Basic PIM Sparse configuration information
•
Group information
•
BSR information
•
Candidate RP information
•
RP-to-group mappings
•
RP information for a PIM Sparse group
•
RP set list
•
PIM neighbor information
•
The PIM flow cache
•
The PIM multicast cache
•
PIM traffic statistics
•
PIM counter statistics
Displaying basic PIM Sparse configuration information
To display PIM Sparse configuration information, enter the following command at any CLI level.
Brocade(config)# show ip pim sparse
Global PIM Sparse Mode Settings
Maximum Mcache : 0 Current Count : 0
Hello interval : 30 Neighbor timeout : 105
Join/Prune interval : 60 Inactivity interval : 180
Hardware Drop Enabled : Yes Prune Wait Interval : 3
Bootstrap Msg interval : 60 Candidate-RP Msg interval : 60
Register Suppress Time : 60 Register Probe Time : 10
Register Stop Delay : 60 Register Suppress interval : 60
SSM Enabled : No SPT Threshold : 1
Route Precedence : mc-non-default mc-default uc-non-default uc-default
---------+---------------+----+---+---------------------+---+---------+-------+------+---------+
Interface|Local |Ver |St | Designated Router |TTL|Multicast| VRF | DR | Override
|Address | | |Address Port|Thr|Boundary | | Prio | Interval
---------+---------------+----+---+---------------------+---+---------+-------+------+---------+
v3 3.1.1.2 SMv2 Ena Itself 1 None default 1 3000ms
v4 4.1.1.2 SMv2 Ena Itself 1 None default 1 3000ms
v10 10.1.1.1 SMv2 Ena Itself 1 None default 1 3000ms
v12 12.1.1.1 SMv2 Ena Itself 1 None default 1 3000ms
v33 33.1.1.1 SMv2 Ena 33.1.1.2 1/14 1 None default 1 3000ms
l1 1.1.1.3 SMv2 Ena Itself 1 None default 1 3000ms
Total Number of Interfaces : 6
Syntax: show ip pim [vrf vrf-name ] sparse
The vrf option allows you to display PIM sparse configuration information for the VRF instance
identified by the vrf-name variable.
This example shows the PIM Sparse configuration information on PIM Sparse device A in