Brocade Multi-Service IronWare Multicast Configuration Guide (Supporting R05.6.00) - Manual (Page 177)

Multi-Service IronWare Multicast Configuration Guide 165
53-1003032-02
IPv6 PIM Sparse
2
Displaying PIM Sparse configuration information and statistics
You can display the following PIM Sparse information:
• Basic PIM Sparse configuration information
• IPv6 interface information
• Group information
• BSR information
• Candidate RP information
• RP-to-group mappings
• RP information for an IPv6 PIM Sparse group
• RP set list
• Multicast neighbor information
• The IPv6 PIM multicast cache
• IPv6 PIM RPF
• IPv6 PIM counters
• IPv6 PIM resources
• IPv6 PIM traffic statistics
Displaying basic PIM Sparse configuration information
To display IPv6 PIM Sparse configuration information, enter the show ipv6 pim sparse command at
any CLI level.
Syntax: show ipv6 pim [vrf vrf-name] sparse
The vrf parameter allows you to configure IPv6 PIM on the virtual routing instance (VRF) specified
by the vrf-name variable.
Table 32 displays the output from the show ipv6 pim sparse command.
Brocade# show ipv6 pim sparse
Global PIM Sparse Mode Settings
Hello interval : 30 Neighbor timeout : 105
Bootstrap Msg interval: 60 Candidate-RP Advertisement interval: 60
Join/Prune interval : 60 SPT Threshold : 1
SSM Enabled: Yes
SSM Group Range: ff30::/12
Hardware Drop Enabled : Yes
Brocade# show ipv6 pim sparse
Global PIM Sparse Mode Settings
Hello interval : 30 Neighbor timeout : 105
Bootstrap Msg interval : 60 Candidate-RP Advertisement interval: 60
Register Suppress interval: 60 Register Stop Delay : 60
Join/Prune interval : 60 SPT Threshold : 1
Inactivity interval : 180 Hardware Drop Enabled : Yes
SSM Enabled : Yes