Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 155)

Brocade Virtual ADX Switch and Router Guide 141
53-1003246-01
Displaying OSPF information
6
Syntax: show ip ospf neighbor [router-id ip-addr] | [num] | [detail]
The router-id ip-addr parameter displays only the neighbor entries for the specified router.
The num parameter displays only the entry in the specified index position in the neighbor table. For
example, if you enter “1”, only the first entry in the table is displayed.
The detail parameter displays detailed information about the neighbor routers.
These displays show the following information.
TABLE 15 CLI display of OSPF neighbor information
Field Description
Port The port through which the Layer 3 Switch is connected to the neighbor.
Address The IP address of this Layer 3 Switch’s interface with the neighbor.
Pri The OSPF priority of the neighbor.
•
For multi-access networks, the priority is used during election of the Designated Router
(DR) and Backup designated Router (BDR).
•
For point-to-point links, this field shows one of the following values:
•
1 = point-to-point link
•
3 = point-to-point link with assigned subnet
Virtual ADX# show ip ospf neighbor detail
Port Address Pri State Neigh Address Neigh ID Ev Op Cnt
9/1 10.2.0.2 1 FULL/DR 10.2.0.1 10.2.2.2 6 2 0
Second-to-dead:39
10/1 10.3.0.2 1 FULL/BDR10.3.0.1 10.3.3.3 5 2 0
Second-to-dead:36
1/1-1/8 10.5.0.1 1 FULL/DR 10.5.0.2 10.16.16.16 6 2 0
Second-to-dead:33
2/1-2/2 10.2.0.1 1 FULL/DR 10.2.0.2 10.15.15.15 6 2 0
Second-to-dead:33