Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 209)

Brocade Virtual ADX Switch and Router Guide 195
53-1003246-01
Displaying OSPFv3 information
7
To display the entire OSPFv3 route table for the device, enter the following command at any level of
the CLI:
Syntax: show ipv6 ospf routes [ipv6-prefix]
The ipv6-prefix parameter specifies a destination IPv6 prefix. (You do not need to specify the length
of the prefix.) If you use this parameter, only the route entries for this destination are shown.
For example, to display route information for the destination prefix 2001:db8:2000:4::, enter the
following command at any level of the CLI:
These displays show the following information:
TABLE 32 OSPFv3 route information
This Field... Displays...
Current Route Count (Displays with the
entire OSPFv3 route table only) The number of route entries currently in the OSPFv3 route table.
Intra/Inter/External (Type1/Type2)
(Displays with the entire OSPFv3 route
table only) The breakdown of the current route entries into the following route types:
•
Inter – The number of routes that pass into another area.
•
Intra – The number of routes that are within the local area.
•
External1 – The number of type 1 external routes.
•
External2 – The number of type 2 external routes.
Equal-cost multi-path (Displays with
the entire OSPFv3 route table only) The number of equal-cost routes to the same destination in the OSPFv3
route table. If load sharing is enabled, the router equally distributes traffic
among the routes.
Destination The IPv6 prefixes of destination networks to which the Brocade device
can forward IPv6 packets. “*IA” indicates the next router is an intra-area
router.
Virtual ADX# show ipv6 ospf routes
Current Route count: 4
Intra: 4 Inter: 0 External: 0 (Type1 0/Type2 0)
Equal-cost multi-path: 0
Destination Options Area Cost Type2 C
Next Hop Router Outgoing Interface
*IA 2001:db8:2000:4::/64 V6E---R-- 0.0.0.0 1 0
:: ethe 3
*IA 2001:db8:2002:c0a8:46a::/64 V6E---R-- 0.0.0.0 1 0
:: ethe 3
*IA 2001:db8:2999::1/128 --------- 0.0.0.0 0 0
:: loopback 2
*IA 2001:db8:2999::2/128 V6E---R-- 0.0.0.0 1 0
fe80::2e0:52ff:fe91:bb37 ethe 3
Virtual ADX#show ipv6 ospf routes 2001:db8:2000:4::
Destination Options Area Cost Type2 Cost
Next Hop Router Outgoing Interface
*IA 2001:db8:2000:4::/64 V6E---R-- 0.0.0.0 1 0
:: ethe 3