Davey HP/T & HS/T Pressure Systems with Torrium2 - Manual (Page 3)

3
NOTE: The Torrium2 ® controller fitted to this pump is adaptive. If your
pump draws air or is subject to blockage, the Torrium2 adapts to its new
maximum pressure. This may result in your system pressure not dropping
below the new cut-in pressure and your pump not starting. Should this
occur, re-prime your pump units as detailed above. Should this not prove
successful, it is likely you have a blockage in the pump. You should
contact your Davey dealer for assistance.
Rotary Coupling Inlet
1” Male
Horizontal Outlet
1” Male
Priming Cap which covers the 1” Male Vertical Outlet
and access to the internal check valve.
Status Indicator
Lights
Prime Button
Pressure
Indicator
Window
Fitting the Torrium2 ® directly to the Pump
The Torrium2 ® is fitted with a rotary coupling. This
coupling allows the pump controller to be fitted
simply and easily to the pump discharge.
The coupling has an oring seal. The controller
adaptor nut is able to rotate independent of the
Torrium2 ® and the complete pump, this allows it
to be tightened onto the pump easily. For ease
of installation a tightening tool is included with
Torrium2 ® to tighten the controller nut to ensure a
firm connection to your controller.
The ability to rotate the adaptor nut also means that the complete controller, once
fitted to the pump, can be rotated a full 360 o in the horizontal plane, without causing
the coupling to unscrew from the pump outlet.
With Torrium2 ® you can connect the discharge pipework to the
discharge port and/or the vertical priming port. The priming port is
able to be used as a discharge port.
WARNING: When servicing or attending pump, always ensure power
is switched off and lead unplugged. Electrical connections should be
serviced only by qualified persons. If the electrical supply lead of this
pressure system is damaged, it must be replaced.
NOTE:
a) For protection, the Davey ® pump motor is fitted with an automatic
“over temperature” cut-out. Constant tripping of this overload device
indicates a problem e.g. low voltage at pump, excessive ambient
temperature (above 50°C) in pump enclosure.
b) The Torrium2 ® control device may have to be reset after rectifying any
of the above operating troubles. This is done by pushing in the “prime”
button and releasing it after 2 seconds, or switching the power supply
off then on.
Care should also be taken when servicing or disassembling pump to avoid
possible injury from pressurised water. Unplug pump, relieve pressure by
opening a tap on the discharge side of the pump and allow any hot water in
the pump to cool before attempting to dismantle.
During servicing, use only approved, non-petrochemical based oring and
gasket lubrication. If unsure, consult your Davey Dealer for advice.
WARNING: Do not use hydrocarbon based or hydrocarbon propelled
sprays around the electrical components of this pump.
In accordance with AS/NZS 60335.2.41 we are obliged to inform you that
this pump is not to be used by children or infirm persons and must not be
used as a toy by children.
NOTE: The Torrium2 ® controller is adaptive. If your pump draws air or is subject to
blockage, the Torrium2 ® adapts to its new maximum pressure. This may result in
your system pressure not dropping below the new cut-in pressure and your pump
not starting. This is more likely to occur when boosting mains pressure. Should this
occur, re-prime your pump unit. Should this not prove successful, it is likely you have
a blockage in the pump. You should contact your Davey dealer for assistance.
10