Davey Hurricane Turbo Swim Jet - Manual (Page 2)

2
FIBREGLASS/VINYL
CUT-OUT OF THE PANEL:
Place the pattern on the inside panel taking the 400 mm
linear dimension between the axis XY and the top of the
structure into account.
Caution: Make sure you position axis XY parallel to the
top of the structure.
Mark the 14 mounting bolt holes on the panel and cut out
the pattern according to the points.
Trace the profile on the panel and carry out the cutting
and drilling.
MOUNTING OF PACKAGE 1 ON THE PANEL:
1- Fitting of the 3 self-adhesive Gaskets:
a) Clean the surface and then stick Gasket (4) to the Counter Flange (2).
b) Clean and then stick Gasket (4) to the back of the Jet Body (1).
c) Clean and then stick Gasket (4) to the flat side of the Flange.
2- Mounting of the Protective Shield:
Mount the Protective Shield (5) using the 3 screws M5 which prevent any kind of deformation of
the liner.
3-Mounting of the Jet Body:
Hold the Counter Flange (2) to the outer side of the panel. Place the Jet Body (1) on the other
side of the panel and keep everything in place by using the 2 fixing screws in A and B.
4-Fixing Bracket for Fibreglass/Vinyl Pools:
After having placed the liner, fill the pool to the base of the Jet Body. Place the Bracket opposite
the Jet Body and place the 12 screws (the liner is simply pierced by the screws). Tighten it
enough for the joint to be well fixed into place but avoid using excessive force. If you are
installing package 2 (= front) immediately, cut the liner with a cutter, otherwise leave in tact.