Chlorine production – Davey MCxxC CHLOROMATIC Salt Water Pool System User Manual

Page 13

Advertising
background image

13

Salt is NOT used up in the process of producing chlorine or by evaporation. Salt is only lost through back -
washing, splash - out, overflow or by leakage from the pool or plumbing. Winter rains can dilute the salt solution in
your pool; therefore salt levels should be checked during this season. In colder water, the ChloroMatic should be
set to Winter Mode. (Refer Winter Mode page 8).

Low salt levels will destroy the coating on the Anode plates and will void all Warranty.
The ChloroMatic

®

has built in warning indicators to minimise damage resulting from insufficient salt levels,

however, the ultimate responsibility is on the owner to ensure adequate salt levels are maintained all year round.

4. RUNNING TIMES:
These instructions cover ChloroMatics for residential use only.
If you run your chlorinator for 24 hours a day, or for long periods, the Cell life will be greatly reduced. It is important
that the correct model ChloroMatic

®

has been installed on your pool. Many models are available to cope with small

courtyard pools up to commercial applications. (Consult your local ChloroMatic

®

Dealer for more information).

CHLORINE PRODUCTION:

The ChloroMatic

®

must be run daily to generate sufficient chlorine to sanitise the pool. During Summer this is

approximately eight hours per day, preferably in two periods - between 6.00 and 8.00am and between 5.00 and
11.00pm. Night time is preferable because chlorine dissipates rapidly in direct sunlight. If these running times are
observed, and the Cell is functioning correctly, your pool will have sufficient chlorine when tested in the morning.
If the level is too low either longer running times are required or the Sanitiser Output Control needs to be
adjusted to maximum. Harsh local conditions such as traffic pollution or windborne dust require different running
times, in which case, seek advice from your pool shop. During Winter approximately 4 to 6 hours a day should
provide enough chlorine. Without sufficient filtration/chlorination, your pool will never function correctly. ALWAYS
RUN THE FILTER WHEN SWIMMING IN THE POOL
. In extremely hot weather or during periods of heavy bathing
loads, the running time may need to be extended to 10 - 14 hours per day.

In some cases you may find your chlorine level to be too high. To determine if this is the case, run your filter/
chlorinator for the suggested times/chlorine production level and test your pool water on the morning after
operation. If your chlorine test shows a high level of chlorine, either the running times can be reduced slightly, or
the Sanitiser Output Control can be turned anti - clockwise. Test your chlorine level again the following morning
at around the same time. If your chlorine level is still high, repeat the above process until the correct level is
attained.

“SHOCK” TREATMENT:
Periodically, especially during extremely hot conditions, it may be necessary to boost the amount of chlorine in
your pool in order to maintain absolute sanitation of the water. This can be achieved by adding either liquid or
granulated chlorine. If granulated chlorine is added, the Cell must be checked regularly, since the additives from
this product will clog the electrodes. Alternatively, extend the running time of your ChloroMatic

®

.

CHLORINE TYPES AND COMPARISONS / MAX POOL SIZE:
Many chlorinator manufacturers calibrate their units to compare with 65% granulated chlorine, making it necessary
to adjust their readings to a lower level in order to determine true chlorine production. The Display on your
ChloroMatic

®

expresses production as pure 100% chlorine so you will know the exact output of your Unit. Below is

a comparison table of the available types of chlorine used to sanitise pools.

ChloroMatic

®

Production

maximum

grams/hour

(100%)

Production*

grams/

hour (65%

equivalent)

Chlorine

produced

over 8 hours

grams

(100%)

Equivalent in

dry granulated

chlorine

grams

(65%)

MAX POOL SIZE (litres)

Model

ESR

Model

ESC

pH

COOL

CLIMATES

TEMPERATE

CLIMATES

HOT &

TROPICAL
CLIMATES

110

11

17

88

136

55,000

34,000

24,000

160

16

16

16

25

128

200

80,000

50,000

35,000

200

20

31

160

248

100,000

62,000

44,000

240

24

24

24

37

192

296

120,000

75,000

55,000

300

30

46

240

368

150,000

94,000

66,000

36

36

36

55

288

440

180,000

112,000

80,000

40

40

62

320

496

200,000

125,000

100,000

50

50

67.5

351

579

250,000

200,000

160,000

Advertising
This manual is related to the following products: