Audiovox NPC5000 - Manual (Page 51)

Mounting instructions
51
English
Initial start-up
1. Reconnect the car battery.
2. Restore perfect functioning of the electrical system (clock, onboard computer,
alarm system, airbag, immobilizer, radio coding, etc.).
3. Switch on the ignition.
4. Insert map CD into the navigation computer.
5. Insert batteries (not supplied) in the battery compartment of the remote control
(accessory), see user manual of the navigation system.
The remote control works without batteries when placed in its holder.
6. Park the car so that the GPS antenna has free “visual contact” to the sky.
7. Start the engine.
The monitor display appears (user advice).
8. Confirm the user advice by pressing OK key on the remote control.
The start menu appears, initialization of the navigation computer then begins
(duration between 2 and 10 minutes).
Configuring the system
Adjusting mounting angle
1. Select “System Information” from the “Settings” menu.
2. Select “Diagnosis” from the “System Information” menu. Then enter code
number “6330” and confirm.
3. Select “Mounting angle” option and adjust angle corresponding to the mounting
situation between - 10 und + 30 degrees.
The system does not distinguish between negative and positive values. Therefore
for example set the value to “10” even if the mounting angle is -10 degrees.
Display adjustment 4:3 / 16:9 (factory default)
1. Enter “Diagnosis” menu as described above.
2. Select “Display” option and select desired setting for the pictogram rectification
(4:3 or 16:9 display type).
Audiovox_MS5000.book Seite 51 Donnerstag, 9. November 2000 3:41 15