Elitegroup G713 - Manual (Page 51)

Do not use benzene, thinners, or cleaners with detergent. Only use DVD-ROM cleaning
kits. •
• Do not bend or drop the discs.
L L o o a a d d i i n n g g a a D D i i s s c c
To play a CD disc, follow the instructions listed below.
1.
2.
3.
1.
2.
3.
Push the DVD-ROM/Combo eject button on the CD drive door. Gently pull the
tray all the way out.
Carefully lift the DVD-ROM/Combo by the edges and make sure the shiny surface
is face down (the side with no writing on it). Carefully insert the DVD-ROM onto
the tray. Push the DVD-ROM down gently so that it snaps onto the center ring.
Push the tray back into the drive.
To remove a disk, do the following:
Check the LED display and make sure that the computer is not accessing the DVD-
ROM drive.
Push the eject button and pull the tray all the way out.
Carefully pick up the CD disk by the edges and – while pressing down on the center
ring – remove the DVD-ROM/Combo from the tray.
Do not insert any foreign objects into the disc tray. If you experience difficulty when
ejecting the CD disk tray, stretch a paper clip (or use a pin or a thin metal rod) and insert it
into the emergency eject hole located on the right side of the front panel. The CD disk tray
should eject immediately. This procedure can also be used to remove a CD from the drive
when the Notebook is powered off.
PCMCIA Cards and Expansion Sockets
The Notebook features one PCMCIA expansion socket design to interface with one Type II
card.
49