Elitegroup G713 - Manual (Page 95)

2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
Open your computer and locate on the 4 grip of the keyboard attaching to the slot.
Use any card to release the keyboard by inserting on the 4 grip attaching the
keyboard.
Turn over the keyboard and locate for the RAM module compartment.
Remove the screws that secure the RAM module compartment cover and set it aside
in a safe place.
Remove the compartment cover and then angling it up and out.
If you need to install a higher capacity module, gently push the edge clips on both
sides to release the module. Angle the card slightly upward and gently slide it from
its edge connector slot. Store the card in the anti-static bag that contains your new
module(s).
To install the new memory card, hold the card with its gold edge connector toward
the edge connector slot of the compartment. To help you orient the cards, the edge
connector has been made with two unequal-length sections. You will only be able
to insert the card in one direction.
Insert the edge connector into the slot. The gold edge connector of the card should
not be visible when the card is fully inserted.
Press the card downward where you should hear an audible click as the latches of
the connector secure the card in place.
Once the module is properly seated, you can replace the cover on this compartment.
Replace and tighten the screw.
Easy to Upgrade HDD Module
The hard drive in your notebook computer is made to be easily swapped out for upgrading.
You should back up your hard drive before attempting o change the hard drive.
Make sure that before you install a new drive, all the files in your system should be backed
up.
93