Antec P280 - Manual (Page 11)

11
2.3 Installing KUHLER H
2
O Liquid Coolers
The following instructs how to install the Antec KUHLER H
2
O liquid CPU cooler (620 / 920). For any other
CPU coolers, please consult your manufacturer’s installation guide.
Caution:
Check your motherboard’s CPU socket to ensure its compatibility with the KUHLER H
2
O. The KUHLER
H
2
O 620 / 920 is compatible with the following CPU sockets:
Intel® LGA 1155 / 1156 / 1366 / 2011*
AMD® AM2 / AM3 / AM2+ / AM3+ / FM1
*Your unit may not contain the LGA 2011 mounting bracket. To acquire this, please contact Antec
customer support (information listed at end of manual).
**Be sure to install the KUHLER H
2
O with the end of the tubes positioned at the bottom of the radiator.
1. Remove the rear fan by first disconnecting the power
connector from the fan power hub directly above the
fan.
2. Remove the screws on the back of the chassis while
supporting the fan with your other hand.
Disconnect the 3-pin power connector.
Unscrew the rear fan to remove it.