5 external 5.25” device installation – Antec P280 User Manual
Page 13
13
2.5
External 5.25” Device Installation
To install a 5.25” drive, you will need to remove the side panel and open the front door. For side panel
removal, please see Section 2.1.
1. With the side panel off, carefully push the drive bay cover out of the drive bay.
2. Slide your 5.25” drive through the front of the chassis until it lines up flush with the front bezel.
You will feel the drive lock into position.
3. If you need more clearance on the inside of the chassis for your drive, pull the drive bay tab on
the inside of the chassis toward you and push the drive in further.
(See step 3 above if you need more clearance
for your drive.)
A
B
C
To install a 5.25” drive, begin by opening the
front door.
Make sure to also remove the side panel as well
(see Section 2.1 for more information)
Slide your 5.25” drive through the front chassis
until it lines up flush with the front bezel.