Antec P280 - Manual (Page 23)

23
Internal intake 120 mm fans
Just outside of the 3.5” drive bay area are
two fan mounts for 120 mm internal
intake fans.
1. Align your fan with the pegs that
correspond with the fan screw
holes on the fan.
2. Push your fan into the slot until
secure. You will hear your fan
lock into place when the brackets
around the fan snap into place.
Secure an intake fan into place by aligning it with the pegs that
correspond with the fan screw holes.
Align your fan with the pegs that correspond with the fan screw
holes on the fan.