Hired-Hand Mega-Cool: Square Reservoir - Manual (Page 17)

Part No. 4801-5397 Rev. 5-08 Mega-Cool System – Square Reservoir Page 17
Flush System – In-Line Pump (In-Line Center Mount Systems 10 ft. to 120 ft.)
It is very important to flush the system. After completing system assembly, follow steps below in order to flush out debris from pipes.
1. Open ball valves at both ends of system. See diagram
above.
2. Turn on water. Fill reservoir to fill line. Fill the Strainer
Basket.
WARNING: Do not over-tighten the Strainer Basket lid.
Hand-tight ONLY.
3. Turn on In-Line Pump to flush out system.
4. After flushing system, turn off In-Line Pump.
5. Close ball valves at end of spray line.
6. Clean In-Line Filter.
7. Resume normal operation.
NOTE: Lubricate the strainer basket lid seal with Vaseline to ensure vacuum-tight
seal.
Ball Valve
1-1/2” Elbow
(3.8 cm)
PVC Tee Reducer
1¼” x 1¼” x 1½”
1" Ball Valve Drain
Pump
Front View
Ball Valve
Strainer
Basket
In-Line
Filter
1 1/2" Ball
Valve
1 1/2" 90°
Elbows