Hired-Hand System 1000 Power Curtain Eight Stage Controller - Manual (Page 16)

System 1000™ Power Curtain™ Controller 13
Recommended Wire Gauge for LOW VOLTAGE hookup.
Component HHI Wiring Part No. Recommended Wire
Sensor 1502-2427 18/2 Shielded Cable
Hall Effect Devices 1502-2427 18/2 Shielded Cable
PVR-H 1503-1508 18/3 Cable SJT
Fan
Motor
Breaker Panel
Hot
120 VAC or
240 VAC
Variable Speed
Wiring
PCB126 (Rev B) 16 Sept 1993
Light/Var
In
Out
In
Out
In
Out
In
Out
In
Out
Var Speed
Stage 8
Stage 7
Stage 6
Stage 5
2 Amp
2 Amp
2 Amp
2 Amp
Monitor Alarm
Com
N.O.
N.C.
Pressure
Yellow
Red
Black
12 Amp
L0
L1
System 1000 Power Curtain
When wiring the Variable speed fans, connect the "hot line" from the breaker panel to the
terminal positions marked "Variable Speed In" on the board in the bottom of the controller.
From the Out connection, run a wire to the fan motor.
For operation with the Remote Fan Drive Unit, you will need to wire the system as shown below.