Hired-Hand PowerTrak - Manual (Page 15)

Part No. 4801-0154 Rev 8-07 PowerTrak Page 15 of 22
Outside Sidewall Mount
This drawing shows a 1:2 ratio.
This drawing shows a 1:1 ratio.
In this figure, the cables are looped
over the pulleys as shown on page 8.
The cable starts on one side of the
load block, Loops over the top pulley,
through the line pulley, back over the
lower pulley, and back to the other
side of the load block.
In this figure, the cables are looped
over the pulleys as shown on page 8.
Then tied off at the tie down loop on
the side of the machine.