Hired-Hand PowerTrak - Manual (Page 5)

Part No. 4801-0154 Rev 8-07 PowerTrak Page 5 of 22
5. Use of Equipment
The PowerTrak is used for the automatic or manual operation of curtains, vents, and doors, by the use of a
cable/pulley system. In the back of the manual are a few of the optional installations. These are not the only
ways to cable the system, just a few typical examples.
6. Installation
6.1 Tools Required
9/16" Socket 3/8" Ratchet and extensions
Cable Cutters Small Screwdriver
11/32 Allen Wrench (included) Wire Strippers
6.2 Instructions
1. Unpack the PowerTrak and check the machine for any physical defects. Open door, then
remove door by pulling up or down on the spring loaded hinge pins.
2. Select mounting configuration chart from back of this manual (outside endwall, inside center,
etc.) which best fits your needs.
Inside Center
Mount
Outside Endwall
Mount
Outside Sidewall
Mount
Outside Center
Mount
Inside Endwal
Mount