Hired-Hand PowerTrak - Manual (Page 6)

Part No. 4801-0154 Rev 8-07 PowerTrak Page 6 of 22
3. Drive one 3/8" lag bolt through the wall of the building in the desired location. Note: Place this
bolt 5.5" below the desired height of the top of the machine.
10.000"
5.500"
2.000"
5.500"
*See Chart
1' 18.375"
2' 30.375"
3' 42.375"
4' 54.375"
5' 66.375"
6' 78.375"
Distance between holes
depends upon length of
machine. For example:
If you have a six foot
machine, the holes should
be placed 78.375" apart.
4. Hang PowerTrak on the lag bolt through the slot near the top of the machine. (See number one
below) Note: This bolt is just for hanging the PowerTrak during installation. Do not attempt to
operate the machine until it is fully secured. To secure the PowerTrak, use the remaining six
3/8" lag bolts provided. Drive the bolts through the four holes in the back wall of the
PowerTrak (Number two below), and the two flange holes near the top (number three below).
1.
2.
3.