Lincoln Electric IM8002 POWER WAVE MANAGER - Manual (Page 45)

ArcLink Chapter 7. Network Settings
IM8002 Power Wave® Manager User Manual 7.3
Pairing Setup
Certain Lincoln Electric components can be “paired” together, such as dual-head wire feeders and user
interfaces. The system usually pairs these automatically for you. However, if there was a problem with
pairing between two or more components, Power Wave® Manager displays the Pairing setup tab (Figure
7.3).
NOTE | If automatic pairing was successful, you will not see the
Pairing setup tab.
Figure 7.3 Pairing Setup Tab
Each module that requires one or more other modules to be paired with it will be shown in the list on the
left, with “slots” that can be filled by modules from the list on the right.
To pair two modules together:
Procedure Details
1. Click an unused slot under the module you
want to pair with another.
Power Wave® Manager displays any other
modules on the right side that are available for you
to pair it with.
2. Click the module on the right and drag it over
to the left and drop it over the unused slot.
You can also click the arrow buttons between the
two panes to move the modules back and forth.
3. Click the Apply settings button.