Lincoln Electric IM591 UWW-170 - Manual (Page 13)

A-6 A-6 INSTALLATION
Line Cord Connection
A 3 conductor international cordset with a 16 amp,
230 volt, two-prong plug is factory installed. Connect
this plug to a mating grounded receptacle which is
connected to an appropriate power supply per any
applicable local codes.
CONNECT TO A SYSTEM
GROUNDING WIRE. SEE
THE UNITED STATES
NATIONAL ELECTRICAL
CODE AND/OR LOCAL
CODES FOR OTHER
DETAILS AND MEANS FOR
PROPER GROUNDING.
CONNECT TO HOT WIRES
OF A THREE-WIRE SINGLE
PHASE SYSTEM OR TO
ONE PHASE OF A TWO OR
THREE PHASE SYSTEM.
This welding machine must be connected to a
power source in accordance with applicable elec-
trical codes.
The United States National Electrical Code (Article
630-B, 1990 Edition) provides standards for
amperage handling capability of supply conduc-
tors based on duty cycle of the welding source.
If there is any question about the installation
meeting applicable electrical code requirements,
consult a qualified electrician.
Grounding
Type 75 ° C Wire Fuse
Wire in Conduit, Copper Size
Input Copper Cond. Cond. (Super
Voltage Hertz AWG Size AWG Size Lag)
230 50/60 8 10 40
WARNING
SP 170-I