Lincoln Electric IM591 UWW-170 - Manual (Page 32)

C-1 C-1 ACCESSORIES
OPTIONAL ACCESSORIES
See Maintenance section for instructions on
installing drive roll, cable liner, contact tip and their
proper configuration.
1. KP665-045C Drive Roll – Optional — Knurled
drive roll for feeding .035 - .045 ” (0.9 - 1.2 mm)
diameter flux-cored electrode.
2. K695-1 Spot / Stitch Timer Kit — Includes spot
timer to control the spot welding arc time, and a
stitch timer to control the on/off cycle time of the
arc to prevent burnthrough on thin gauge metals.
Also includes spot welding nozzle.
The Spot/Stitch Timer Kit installs inside the wire
feed compartment, replacing the blank panel locat-
ed below the gun trigger lead connectors, per the
installation instructions (M17920) included with the
kit.
3. K520 Utility Cart — Designed to transport the
Lincoln family of small welders. Has provisions for
mounting a single gas cylinder. Has front casters
and large rear wheels. Handle height is easily
adjustable. Bottom tray provided for tools and
accessories. Easy assembly required; takes less
than 15 minutes.
4. K464 .035" (0.9 mm) Innershield ® Welding Kit
— Includes a contact tip, a gasless nozzle and a
.035/.045" (0.9/1.2 mm) cable liner to permit the
gun and cable to use .035" (0.9 mm) diameter flux-
cored electrode. The fitting on the end of the liner
is stenciled with the maximum rated wire size
(.045"/1.2 mm). Also included is a 10 lb.(4.5 kg.)
spool of .035" (0.9 mm) Innershield
® NR-211-MP.
For use with “ Lincoln Electric ®” gun (with black
trigger). The end of the brass fitting on the end of
the .035/.045
” (0.9/1.2mm) liner is color coded
green. (The .023-.030 ” (0.6-0.8mm) liner is color
coded orange).
See “ Innershield (FCAW) Conversion ” in this sec-
tion for installation instructions and MAINTE-
NANCE section for proper feeding component con-
figuration and installation.
5. K491 .045" (1.2 mm) Innershield ® Welding Kit
— Includes a contact tip, a gasless nozzle and a
.035/.045" (0.9/1.2 mm) cable liner to permit the
gun and cable to use .045" (1.2 mm) diameter flux-
cored electrode. The fitting on the end of the liner
is stenciled with the maximum rated wire size
(.045"/1.2 mm). Also included is a 10 lb.(4.5 kg.)
spool of .045" (1.2 mm) Innershield
® NR-211-MP
and a knurled drive roll for .035 ” (0.9mm) and .045 ”
(1.2mm) wire.
For use with “ Lincoln Electric ®” gun (with black
trigger). The end of the brass fitting on the end of
the .035/.045
” (0.9/1.2mm) liner is color coded
green. (The .023-.030 ” (0.6-0.8mm) liner is color
coded orange).
See “ Innershield (FCAW) Conversion ” in this sec-
tion for installation instructions and MAINTE-
NANCE section for proper feeding component con-
figuration and installation.
SP-170-I