LumaSense Technologies M67 - Manual (Page 6)

M67, M67S Manual
5
1. Limited warranty
/XPD6HQVH7HFKQRORJLHV,QFwill repair or replace at its plant any parts or materials found defective, due to flaws in design or
manufacture, when reported in writing within one year from date of shipment. Instruments to be repaired under this warranty are
to be returned to the factory, freight pre-paid by the user, who assumes all risk and cost of shipping to and from the plant.
This warranty is void if the instrument is disassembled, tampered with, or altered without prior consent of /XPD6HQVH, or
otherwise damaged, or if considered by to be abused or used in abnormal conditions. /XPD6HQVH
This warranty shall constitute the exclusive remedy available to the user and shall be considered a condition of sale and use.
/XPD6HQVH shall not be liable for any loss, or damage including loss of profits or consequential damage resulting from, or
attributed to the use of the M67/M67S Series or resulting from a defect in design or manufacture of the product.
The user shall determine the particular use to which the M67/M67S Series shall be applied and /XPD6HQVH excludes and
disclaims any warranty that the product is fit for such a use.
2. Unpacking and inspection
Check container contents against the shipping list. Save all packing materials, including the carrier's identification codes, until
you have inspected the Infrared Thermometer and find that there is no obvious or hidden damage. Before shipment, the Infrared
Thermometer was examined and has been tested. If you note any damage or suspect damage, immediately contact the carrier
and /XPD6HQVH.
2.1 Storage
In case the Infrared Thermometer is not put into service immediately, it should be tested in the application or simulated
application to reveal any hidden damage. Unpleasant surprises can be avoided by briefly trying any spare Infrared
Thermometer, before putting it in storage. Storage temperature is from -60°C to 60°C (-76°F to 140°F).
3. Description
3.1 Purpose
The INFRADUCER is a device used to measure the temperature of remote objects without physical contact. Hot objects emit
infrared radiation, which is captured by the instrument. The thermal radiation intensity received is related directly to the object
temperature. The INFRADUCER converts the radiation to an electrical signal, which is linearly proportional to the temperature
of the object. This signal may be sent to other instruments, controllers, recorders, etc.
Your M,.521 INFRADUCER is a precision engineered device which is thoroughly tested and operation must be in accordance
with the procedures described in this manual. If you have any questions, please contact /XPD6HQVH, before proceeding, at:
Tel:   
Fax:   
You will obtain the most reliable and accurate service from the INFRADUCER by following maintenance procedures as
described in this manual.
3.2 Applications
Numerous applications exist where the temperature of remote objects must be measured accurately. Examples are:
 Refractory walls in a furnace.
 Molten glass in a furnace or forehearth.
 Temperature of burner flame.
 Thin plastic or glass ribbons.
 Textiles, printing, paper, food, rubber, and other web processes.
 Automatic inducting heating.