LumaSense Technologies INNOVA 1303 - Manual (Page 14)

Chapter 2
________________________________________________________________________
_______________________________________________________________________
BE1085-14
1303 Multipoint Sampler and Doser LumaSense Technologies A/S
Page 14 of 60
2.1 Preliminary
2.1.1 Environment and Handling
The Type 1303 Multipoint Sampler and Doser is designed for use in en-
vironments with temperatures between +5°C and +40°C (+41°F and
+104°F) and with up to 90% relative humidity (non-condensing) at
40°C. Other than ensuring correct connection of the mains supply, no
special handling precautions are necessary.
2.1.2 Connecting the Mains Supply
The 1303 is operated from a 50 to 60 Hz single phase AC mains supply.
Voltage 100-240 Vac.
Before connecting the mains supply, the following checks and adjust-
ments should be performed to ensure safe operation of the 1303.
2.1.3 Checking the power Cord
Use the power cord supplied with the 1303 or check that the Cord used
is rated minimum 10A / 250V.
Checking Fuse Rating
Use a small flat-bladed screwdriver to prise open the flap surrounding
the AC Mains switch. See Fig. 2.1.
Fig.2.1. Accessing the 1303’s fuses
Again using the screwdriver, gently lever the fuse-holders out from
their slots. See Fig. 2.2 .