Rhino Shelter ROUND-30W X 40L X 15H - Manual (Page 10)

Assembly Instructions
30x40x15 Round Style Portable Building With Single Door
10
Version 2.0
Please DO NOT return unit to store or dealer. For all questions or shortages please contact
Customer Service at: 800-447-7079 or 203-877-7070
Next take up slack in tie bands by ratcheting the
mechanisms tightening cover. Evenly adjust ratchets on
both sides of main cover to take wrinkles out of main cover. Do NOT fully tighten cover yet. Leave adequate
slack so that cover can also be adjusted front to back in
next step.
Step #10 – Tighten Main Cover on Frame Front
To Back
The main cover is tensioned from front to back by the
rope (34) lacing to grommet flaps inside the main cover,
inside the unit at front and rear arches. Using the rope
(34) provided, lace the main cover grommet flap around
the main frame front and rear arch pieces. Start in the
top middle of each arch, and lace to each side. Add
rope (34) length by tying pieces together or cutting as
necessary.
Rope Lacing Main Cover Front-Back
Begin with the front arch at the top. Pull the rope
through the middle grommet until both ends of the rope
meet. Loosely lace the rope down each side, without
pulling the rope taut yet. Then lace the rear grommet
flap to the rear arch frame the same way. Tie off one
end to the lower frame member. Now go back to the top
again, and start taking the slack out of the rope evenly