Rhino Shelter ROUND-30W X 40L X 15H - Manual (Page 16)

Assembly Instructions Round Style 30x40x15
Industrial Round Style Building
16
Version 2.0
Please DO NOT return unit to store or dealer. For all questions or shortages please contact
Customer Service at: 800-447-7079 or 203-877-7070
Double Pulley Nearest Winch Assembly
-
Single Door Pulley Farthest From Winch Assembly
6. The Winch Assembly has a long and a short
steel cable secured to it. Feed the end of the
shorter of the two cables through the lower roller
of the double pulley at the top of the door
assembly track closest to the Winch Assembly,
and then down through the holes in each of the
Door Roller Tubes (16), to the Bottom Door
Tube Dropping Tube (19) on the left hand side
of the door (facing from the inside). The steel
cable should be threaded through the holes in
the ends of the Middle Door Dropping Tubes
(16) as it goes down. When the steel cable
goes down though the hole in the Bottom
Dropping Tube (19), tie a knot in the steel wire
so that it cannot pass back up through the hole.
7. From the Winch Assembly route leading end of
the Longer Steel Cable through the Upper Roller
of the double pulley near door track and then
through the Single Roller on the door track
farthest from the Winch Assembly. Then down
through the Bottom Door Dropping Tube (19).
When the steel cable goes down though the
hole in the Bottom Door Dropping Tube (19), tie
a knot in the steel cable. Door can now be
opened or closed by operating the Winch
Assembly. Raise and lower the door several
times to be certain door tube ends are not
binding on track. Lubricate if necessary.
Door in the fully Closed Position
Door can now be opened or closed by operating the
Winch Assembly. Raise and lower the door several
times to be certain door tube ends are not binding on
track. Lubricate if necessary.