Rhino Shelter ROUND-30W X 40L X 15H - Manual (Page 15)

Assembly Instructions Round Style 30x40x15
Industrial Round Style Building
15
Version 2.0
Please DO NOT return unit to store or dealer. For all questions or shortages please contact
Customer Service at: 800-447-7079 or 203-877-7070
Winch Assembly Mounted To Lower End panel
Beam
3. Slide Bottom Dropping Tube (19) into the bottom
horizontal fabric pocket on the Door Cover (32).
Then slide the six remaining middle door
Dropping Tubes (16) into the remaining
horizontal fabric pockets in the Door Cover, and
use the M5x10 Self-tapping screws (26) to
secure the door cover to the dropping tube.
Door Fabric Before Tubing
4. From the bottom of the door tracks (10,11),
gently raise and slide one door dropping
tube(16) into the tracks. And then feed the other
remaining door dropping tubes (16,19) into the
door tracks.
5. Next install the steel wire that leads from the
door winching assembly to the bottom of the
door dropping tubes. The Winch Assembly has a
long and a short steel cable secured to it. Feed
the end of the shorter of the two cables through
the lower roller of the double pulley at the top of
the door assembly track closest to the Winch
Assembly, and then down through the holes in
the Bottom Door Dropping Tube (19) on the left
hand side of the door (facing from the inside).
When the steel cable goes down though the
hole in the Bottom Dropping Tube (19), tie a
knot in the steel wire so that it cannot pass back
up through the hole.
Bottom Door Base Tube Inserted into Door Track
Door Tubes Inserted Into Door Track