American Water Heater 318935-003 - Manual (Page 18)

18
FOR YOUR SAFETY READ BEFORE LIGHTING
A. This appliance has a pilot which is lighted by a
piezoelectric igniter. When lighting the pilot, follow these
instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
‡ Do not try to light any appliance.
‡ Do not touch any electrical switch; do not use any
phone in your building.
‡ Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
‡ If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control
temperature knob. Never use tools. If the knob will not
push in or move by hand, don’t try to repair it, call a
qualified service technician. Force or attempted repair
may result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance. Water heaters subjected to flood
conditions or anytime the gas controls, main burner or
pilot have been submerged in water require replacement
of the entire water heater.
E. DO NOT USE THIS APPLIANCE IF THERE HAS BEEN AN
IGNITION OF VAPORS. Immediately call a qualified service
technician to inspect the appliance. Water heaters
subjected to a flammable vapors ignition will show a
discoloration on the air intake grid (bottom of combustion
chamber) and require replacement of the entire water heater.
WARNING: If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
TO TURN OFF GAS TO APPLIANCE
1. Turn the gas control/temperature knob counterclockwise to
the "OFF" setting. The status light will stop blinking and stay on for a
short time after the water heater is turned off.
LIGHTING INSTRUCTIONS
5. 1. STOP! It is imperative that you read all safety warnings
before lighting the pilot.
2. Turn the gas control/temperature knob counterclockwise
to the "OFF" setting.
3. Wait ten (10) minutes to clear out any gas.
If you then smell gas, STOP! Follow “ B” in the safety
information above on this label. If you do not smell gas,
go to the next step.
4. Turn the gas control/temperature knob clockwise
to “ PILOT” .
Igniter
Button
Gas control/
temperature knob
Status light
120° F (48.9° C)
Mark
Index mark
Press the gas control/temperature knob all the way in
and hold it in. The knob should travel in about 1/4 inch
(6.35 mm) if it is set to "PILOT" correctly.
While holding the gas control/temperature knob in,
click the igniter button continuously (about once a
second) for up to 90 seconds or until Status Light
begins to blink.
If the status light turns solid red, release the gas
control/temperature knob and repeat steps 2 through 5
(waiting 10 minutes before attempting to relight the pilot).
6.
If the status light does not start blinking after three lighting
attempts, turn the gas control/temperature knob to "OFF"
and call a qualified service technician or your gas supplier.
When the status light starts blinking, release the gas
control/temperature knob. Set the gas control/ tempera-
ture knob to the desired setting.
If the status light does not start blinking within 90
seconds, repeat steps 2 through 5 up to THREE (3)
times, waiting 10 minutes between lighting attempts.
The circuitry in this advanced gas valve requires that
you wait 10 minutes between lighting attempts.
Thermopile
Pilot