American Water Heater 318935-003 - Manual (Page 32)

32
REPAIR PARTS ILLUSTRATION
1A
2
3
8
5A
10
11
9
7
6A
6B
5B
4
1B
LEGEND
Special anode rod (see page 21)
Temperature and Pressure Relief Valve is required,
but may not be factory installed
Unique: Flame Guard™ Safety System parts
When ordering repair parts always give the following
information:
1. Model, serial, and product number
2. Type of gas
3. Item
number
4. Parts description
Repair Parts List
Item
No.
Parts Description
1A DRAFT HOOD
1B DRAFT HOOD (50K Models only)
2 REDUCER RING - SOME MODELS
3 FLUE BAFFLE
4 HEAT TRAP (COLD) - SOME MODELS
5A HEAT TRAP (HOT) - SOME MODELS
5B HEAT TRAP/NIPPLE COMBO (HOT)
(50K Models Only)
6A COLD WATER DIP TUBE
6B HEAT TRAP/NIPPLE/DIP TUB COMBO (COLD)
(50K Models Only)
7 ANODE ROD
8 TEMPERATURE & PRESSURE RELIEF VALVE
(LOCATED TOP OR SIDE)
9 DRAIN VALVE
10 GAS CONTROL VALVE/THERMOSTAT
10 CONTROL MODULE
11 OUTER DOOR
12A* PILOT/THERMOPILE ASSEMBLY KIT
12B* PILOT/THERMOPILE ASSEMBLY KIT (50K Models)
13A* BURNER DOOR ASSEMBLY
(Natural Gas/Low Nox)
13B* BURNER DOOR ASSEMBLY (50K Models)
(Natural Gas/Low Nox)
14* MANIFOLD COMPONENT BLOCK
15* BURNER DOOR GASKET
16* VIEWPORT ASSEMBLY
17* FLEXIBLE MANIFOLD TUBE
18* TEMPERATURE SENSOR
19* THERMOPILE
*Pictured on next page.