Vehicle presets, Driving off, Idle mode – Autostart CT-5060 User Manual

Page 3

Advertising
background image

P. 3

User Guide

CT-5060

• Door opened;

• Hood opened;

• Brakes pressed;

• Parking Brake disengaged;

• Key turned to the

IGNITION ON (RUN)

position.

Should any of the above occur, Ready Mode will be cancelled.
Note: The unit will notify the user that it has exited Ready Mode by giving three slow
flashes of the vehicle’s Parking Lights.

Vehicle Presets

Heater & Heated Seat

When leaving the vehicle it is recommended to preset the accessory controls in

preparation for the next remote start. Settings for the blower motor (fan), front and rear,

as well as heated seats (if equipped) should not be left on

HIGH

. It is recommended to

leave the settings on

LOW

or

MEDIUM

instead.

Windshield Wipers & Radio & Headlights

Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to

become energized while running under remote start. When leaving the vehicle you must
ensure that the windshield wiper and headlight switches are

OFF

. Leaving the headlight

switch

ON

on certain vehicles could cause them to remain

ON

even after remote starter

shut down, resulting in a dead battery.

Driving Off

With the vehicle running under remote control, press the

UNLOCK

button to

DISARM

and

UNLOCK

the doors. Enter the vehicle and do the following:

• Turn the ignition key to the

IGNITION ON (RUN)

position. (Do not turn the key to the

START

position while the engine is running. This will cause the starter motor to re-engage.)

• Press the brakes to disengage the remote starter unit.

You are now ready to drive off.

Idle Mode

This feature allows you to remove the key from the ignition and leave the vehicle running

for its pre-programmed run time while you are away from your vehicle. This feature is

handy if you need to stop for a quick delivery, or at a convenience store.

To enable the Idle Mode:
1. Press and hold

LOCK

,

UNLOCK

or

START/STOP

on your transmitter while the engine is

running.

2. The parking lights will come

ON

.

3. Remove the key, exit the vehicle;

• Press the

LOCK

button if you need to lock the doors while the engine is running.

Caution: Do not leave children or pets unattended in a car running in Idle Mode.

Advertising