Ignition re-lock, Secure lock, Remote trunk release – Autostart CT-5060 User Manual

Page 8: Starter kill, Engine run time, Multi-car operation

Advertising
background image

CT-5060 User Guide

P. 8

Ignition Re-Lock

When the Ignition-Controlled Door Locks option is enabled and the ignition is

ON

, should

any door be unlocked and opened, all the doors will be re-locked next time the brake

pedal is pressed.

Secure Lock

This is an added security feature. If your system was installed with the Secure Lock
option, it will automatically lock your doors and arm the system 4 seconds after your start

your car by remote. The system will automatically lock the doors again after shut-down.

Remote Trunk Release

If your system was installed with the Remote Trunk Release, you can open your trunk by

pressing the

TRUNK

button for 3 sec. on the transmitter, or by pressing the

TRUNK

button

twice within 3 sec.

Starter Kill

This added security feature will immobilize your vehicle when the system is armed. If
your system was installed with the Starter Kill option, you will not be able to start your

vehicle with the key unless the system has been disarmed first.

The Starter Kill option follows the Alarm arming function, and can therefore be

programmed to be active (will not arm automatically) or passive (will arm automatically).
In passive Mode, the Starter Kill can be set to arm automatically in 30 seconds either

with or without Siren chirps.

To disarm the Starter Kill, press and hold the

UNLOCK

button on the transmitter. The

parking lights will flash twice. (If door locks were installed, this will also unlock the doors.)
In passive Mode, the system will automatically re-arm itself 30 seconds after unlocking

the doors if the key has not been inserted in the ignition by then.

To arm the Starter Kill, press and hold the

LOCK

button on the transmitter. The parking

lights will flash once. (If the door locks were installed, this will also lock the doors.)

Engine Run Time

If you have a gas engine, your system can be programmed to run the engine for 4, 15, or
25 minutes (15 min default). If you have a diesel engine, it can be programmed to run the

engine for 9, 20, or 30 minutes (20 min default).

Multi-Car Operation

This option allows the owner of two vehicles, both equipped with identical systems, to

control both systems with only one remote transmitter. To control the second vehicle,

simultaneously press the

TRUNK

button and the button of the function you wish to use:

• Press

TRUNK

+

LOCK

button simultaneously: ..................

LOCK

• Press

TRUNK

+

UNLOCK

:...................................................

UNLOCK

• Press

TRUNK

+

START/STOP

: .............................................

START

• Press

TRUNK

+

START/STOP

:..............................................

STOP

• Press

TRUNK

+

LOCK

+

UNLOCK

:........................................

AUX 3 (TRUNK)

• Press

TRUNK

+

START/STOP

for 3 sec:...............................

COLD WEATHER MODE

Advertising