Autostart CT-5060 - Manual (Page 5)

P. 5 User Guide CT-5060
In an emergency situation, you can activate Panic Mode using the
LOCK
or
UNLOCK
button.
This will:
• Shut down the engine,
• Unlock the doors (if
UNLOCK
is
pressed)
• Or lock the door (if
LOCK
is
pressed),
• Disarm the Starter Kill and
• Activate the siren for 1 minute.
(See below for a description of the Starter
Kill.)
To activate Panic Mode
• Press and hold the
UNLOCK
button for approximately 3 seconds until the siren starts to
sound and the parking lights flash: this will unlock the doors before the siren sounds.
• Or press and hold the
LOCK
button for approximately 3 seconds until the siren starts to
sound and the parking lights flash: this will lock the doors before the siren sounds.
Panic Mode will automatically shut down after 1 minute.
Note : To stop Panic Mode before the 1-minute delay, press the LOCK or UNLOCK button until
the siren stops.
Quick Lockout TM
(Also called Secure Panic.) For fast protection, the system will
LOCK
all doors when you
press the brake pedal while the siren is sounding. (Quick Lockout is only available
when Panic has been activated.)
Cold Weather Mode
When the Cold Weather Mode is active, the engine starts every 2 hours and runs for 4
minutes (or for 9 or 20 minutes with Diesel engines); the routine will go on for a period of
24 hours.
To enter Cold Weather Mode:
• Press and hold the
START/STOP
button for 3 seconds until the parking lights flash
3 times.
(If Safe Start is enabled, the
START/STOP
button must be pressed beforehand – see
below.)
To enter Cold Weather Mode if Safe Start has been activated:
• Press and release the
START/STOP
button, then press and hold the
START/STOP
button for
3 seconds until the parking lights flash 3 times.
To exit Cold Weather Mode, do any one of the following:
• Open the hood.
• Start the engine using the remote control.
• Turn the ignition key to the
IGNITION ON (RUN)
position.
• Press and hold the
START/STOP
button for 3 seconds. (The parking lights will flash once.)
To check whether Cold Weather Mode is active, press and release the brake pedal: the
parking lights should stay on while your foot is on the brake pedal.