Climb milling, 2 climb milling -6, Igure – Walker Magnetics TURBOMILL 40B User Manual
Page 17: Limb, Illing
Advertising
O.S. WALKER Co. Inc., Turbomill Electroperm Chucks
DD15508M.doc Rev. ~, September 17, 2002
4-6
4.6.2 Climb Milling
The machining force F is downward toward the chuck and to the bottom right hand
corner of the work piece. Therefore, the end stop is placed at the end where the cut
starts. As the cut proceeds, the machining force helps to hold the work piece down onto
the chuck face. This means that heavier cuts can be taken in climb milling.
Figure 4-4 Climb Milling
Advertising