Walker Magnetics TURBOMILL 40B - Manual (Page 25)

O.S. WALKER Co. Inc., Turbomill Electroperm Chucks
DD15508M.doc Rev. ~, September 17, 2002
5-1
5 INSPECTION AND MAINTENANCE INSTRUCTIONS
5.1 Daily Inspection
•
Inspect the holding surface of your magnetic chuck. It must be clean, smooth, flat, and free
of nicks or burrs in order to minimize the air gap between the chuck holding surface and the
Work piece. All Walker chucks are designed with soft, low carbon steel magnetic poles in
the chuck in order to maximize the holding capacity; therefore, special care must be taken
to protect these areas. Regrind when necessary (see section 3.1)
•
The cord must be free of nicks and cuts. Replace if damaged.
•
Inspect the receptacle for damage or wear. Make necessary repairs.
•
Perform an overall inspection of the chuck for wear or damage and correct any
deficiencies.
5.2 Replacement Parts List
•
Electrical receptacle
•
Cord
•
Clamps
•
Rails
•
Risers
Contact O.S, Walker for specific part numbers for your model chuck.