WEN 4210 10 inch Drill Press with Cross Hair Laser - Manual (Page 10)

10
Assembly and adjustments (continued)
Tools needed for assembly
• Adjustable wrench
• Phillips® screwdriver
• Hammer and block of wood
Base to column (Fig. 3)
1. Set the base (1) on the floor.
2. Place the column tube (2) on the base (1), align the
column support holes with the base holes.
3. Install a bolt (3) in each column support hole and tighten
with the wrench.
Table to column (Fig. 4–7)
1. Loosen set screw (2) in rack collar (1) and remove the collar.
2. Remove the rack (3) from the column (4).
3. Insert worm shaft (5) into the hole of the table support
crank handle (6) from inside the table support. The worm
shaft (5) should extend outside the housing about 1” (25
mm).
4. Insert the rack (3) into the geared groove of the table
support (6). Make sure the worm shaft (5) on the inside of
the table support is engaged with the teeth of the rack. The
table support should sit at the center of the rack.
5. Slide the table support and rack assembly (3, 5, and 6)
down together onto the column. Insert the bottom edge of
the rack into the lip (7) of the column support. Hold in this
position until step 6 is completed.