WEN 4210 10 inch Drill Press with Cross Hair Laser - Manual (Page 16)

16
Assembly and adjustments (continued)
WARNING: Disconnect the drill press from the power source before making any speed
adjustments.
Adjust speeds and tension the belt (Fig. 18)
1. Open the drill press pulley cover (1).
2. Loosen the belt tension knobs (2) on both sides of the
drill press head.
3. Pull the motor (3) toward the drill press head.
4. Set the belt on the desired steps of the motor (4) and
spindle (5) pulleys according to the belt positions on
the spindle speed chart (Fig. 17).
5. Pull the motor away from the drill press head to
increase the belt tension. Tighten the tension knobs (2).
6. The belt (4) should be tight enough to prevent slippage.
Correct tension is set if the belt flexes about 1/2" (13
mm) when thumb pressure is applied at the midpoint
of the belt between the pulleys.
Table adjustments
Raise or lower the table
(Fig. 19)
1. Raise or lower the table by loosening the column lock
handle (1) and turning the crank handle (2) until the
table is at the desired height.
2. Tighten the table lock handle (1) before drilling.
3. Rotate the table around the column by loosening the
column lock handle (1) and turning the table around
the column to the desired position.
4. Tighten the lock handle before drilling.