WEN 21C Engraver 13Watt - Manual (Page 2)

Specifications
Input power: 13W
Power supply: 120V, 60 Hz
No-load speed: 7,200 SPM (stroke per minute)
Engraving tip: Tungsten Carbide Tipped Steel
Weight: 12 oz
Includes
Engraver, Tungsten carbide tip, 2 pieces Stencils, Allen wrench, instruction manual.
Safety instructions
Safety is a combination of common sense, staying alert, and knowing how your engraver works.
SAVE THESE SAFETY INSTRUCTIONS.
1. READ and become familiar with this entire instruction manual. LEARN the tool’s
applications, limitations, and possible hazards.
2. AVOID DANGEROUS CONDITIONS. Do not use power tools in wet or damp areas or
expose them to rain. Keep work areas well-lit.
3. DO NOT use power tools in the presence of flammable liquids or gases.
4. ALWAYS keep your work area clean, uncluttered, and well-lit.
5. KEEP BYSTANDERS AT A SAFE DISTANCE from the work area, especially when the
tool is operating. NEVER allow children or pets near the tool.
6. DO NOT FORCE THE TOOL to do a job for which it was not designed.
7. ALWAYS remove the power cord plug from the electric outlet when making adjustments,
changing parts, cleaning or working on the tool.
8. AVOID ACCIDENTAL START-UPS. Make sure the power switch is in the OFF position
before plugging in the power cord.
9. NEVER LEAVE A RUNNING TOOL UNATTENDED. Turn the power switch to OFF. Do
not leave the tool until it has come to a complete stop.
10. DO NOT operate the tool if you are under the influence of drugs, alcohol, or medication that
could affect your ability to use the tool properly.
11. DO NOT attempt to use on anything other than the following materials: wood, glass, leather,
ceramic, metal and plastic.
12. ALWAYS wear safety goggles to prevent any loose pieces from flying into your eyes.